Kukko Narrow 2-Arm Revers Quick Adj 3.5-Ton Capacity 4-3/4"(120mm) Open 3-7/8"(100mm) Reach 20-10+S

This item is NOT returnable.

For removing bearings gears discs etc. For tight or difficult-to-access spaces. Ul style"margin-top0px; padding-top 5px; padding-bottom 5px;" the thin pulling hooks are suitable for narrow difficult-to-access locations. A manual adjustment knurl allows rapid loosening and adjusting of the extractor jaws on the cross-beam without using a wrench. Can be installed on various pulling hooks and variable reach thanks to jaw extensions. Turning the pulling hooks enables them to be used both internally and externally. Suitable for pulling asymmetric workpieces. Spindle head band prevents the wrench from slipping off. Cross-beam with hexagonal profile for good grip. Almost all components available as replacement parts time-saving order process thanks to numbering system. Note pressure pads from series 600-17 are a good addition if the shaft is hollow and the spindle cannot be supported. Stability support from optional series 219 clamp. Thin pulling hook with quick adjusting capability quick adjust. Parallel pulling hooks in every position even with full load. Pulling hooks with infinitely variable adjustment on the cross-beam. Optimal adjustment of the spindle to the shaft with 2-sided spindle tip (ball and tip). Mechanical pressure screw. Milled thread treated with special coating. Two-arm design for space-saving operation. The pulling hooks sliding parts must always sit stably and fully on the cross-beam. If several parts have to be removed always follow a step-by-step process. Do not remove several parts at the same time. The pulling hooks support surfaces must always be straight and sit fully beneath the part to be removed. Do not use any electrical or pneumatic servo screwdrivers or hammer drills. Protective blanket required. Protective goggles required. Ul style"margin-top0px; padding-top 5px; padding-bottom 5px;" maximum load (metric) 2 5t hexagon drive (male) (metric) 17mm spread (metric) 30 - 120mm spread used internal 2 3/4

Additional Information