Perle S-1110DP-S1SC40D - Fiber media converter - GigE - 10Base-T, 100Base-TX, 1000Base-T, 1000Base-BX - SC single-mode / RJ-45 - up to 24.9 miles - 1490 (TX) / 1310 (RX) nm MPN:05082194

Pause (IEEE 802.3xy). Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter supports pause negotiation on the 10/100/1000 Base-T connection and 1000Base-X fiber connection. Auto-negotiation (802.3u). The media converter supports auto negotiation. The 1000Base-X fiber interface negotiates according to 802.3 clause 37. The 10/100/1000 Base-T negotiates according to 802.3 clause 28 and 40. The 1000Base-X will link up with its partner after high common denominator (HCD) is reached and the copper has linked up with its partner. The 1000Base-X will continue to cycle through negotiation transmitting a remote fault of offline until the copper is linked up and the HCDs match. Smart link pass-through. When the link mode switch is placed into smart link pass-through mode, the copper Ethernet port will reflect the state of the 1000Base-X media converter port. This feature can be used whether fiber auto-negotiation is enabled or disabled. PD power reset. Ideal for remotely resetting equipment, this configurable function performs a momentary power reset to the attached Powered Device (PD). When enabled, the media converter will, upon loss of fiber RX, turn off PSE output power supplied to the PD device for 2 seconds then turn the power back on and leave it on until such time that another fiber RX link is lost. When disabled, a loss of fiber RX has no effect on PSE power to the PD device. Fiber fault alert. With fiber fault alert the state of the 1000Base-X receiver is passed to the 1000Base-X transmitter. This provides fault notification to the partner device attached to the 1000Base-X interface of the media converter. If the 1000Base-X transmitter is off as a result of this fault it will be turned on periodically to allow the condition to clear should the partner device on the 1000Base-X be using a similar technique. Auto-MDIX. Auto-MDIX (automatic medium-dependant interface crossover) detects the signaling on the copper Ethernet interface to determine the type of cable connected (straight-through or crossover) and automatically configures the connection when enabled. The media converter can also correct for wires swapped within a pair.

Features

Additional Information